Filter Results By:
Products
Applications
Manufacturers
Improvised Explosive Device
a cobbled together makeshift bomb. AKA: IED
- TEAM SOLUTIONS, INC.
product
IEEE-488 GPIB Device Interface IC (Chip) for the PCI-Bus
GPIB-72120
The i72120 GPIB-Chip is the ideal solution to implement a IEEE488.2 GPIB interface for next generation PCI based instruments. The GPIB-ASIC is designed to meet all of the functional requirements for talker and listener (TL) devices as specified by the IEEE Standards 488.1-1987 and 488.2-1987. Connected between the PCI bus and the GPIB, this GPIB-IC provides high-level management of the GPIB to unburden the processor and to simplify both hardware and software design. The i72120 is fully compatible with the PCI specification and requires only the addition of bus driver/receiver components to implement a talker/listener GPIB interface.
-
product
Boat Mount with Pan & Tilt 2D Forward Looking Sonar
Deployed from a patrol boat, Teledyne BlueView's BV3100 is ideal for search and recovery operations, dive team situational awareness, and diver vectoring. It is also an effective means of harbor bottom inspection as well as diver and underwater IED detection.The BV3100 uses Teledyne BlueView's 2D forward looking sonar mounted to a digital pan and tilt system to deliver clear, streaming imagery during both confined and wide area searches. This real-time imagery is produced whether moving or stationary, even in zero visibility water conditions. The BV3100 can be used alone or as a complement to side scan sonar by allowing the user to reacquire and guide divers to targets found in side scan imagery.
-
product
Stationary Bomb Jammers
Security Intelligence Technologies, Inc.
The stationary jammer is used to combat the use of remote controlled improvised explosive devices when terrorists and criminals target a building, checkpoint, or gathering place. The stationary jammer is a bomb jammer that gives off an extended area of coverage.
-
product
Automation Control
Schweitzer Engineering Laboratories, Inc.
Monitoring and controlling substation power systems requires comprehensive solutions. SEL’s complete solutions and hardened devices help maintain system stability with deterministic control; streamline access to valuable IED data, communications processors, and field devices; and improve visualization and control with local HMIs and access to SCADA systems.
-
product
Dirty Bomb Detection Jamming System
Security Intelligence Technologies, Inc.
The SSR-7000 consists of a radiation detection system that operates in concert with a MM Wave body scanner and an electronic countermeasure IED Defeat System. This three part solution is geared to deal with finding remote controlled weapons that are designed to detonate radioactive contents with a discharge that may or may not reach nuclear yield. Dirty bombs of this type are designed to cause terror and maximum panic.
-
product
Asset Management
Schweitzer Engineering Laboratories, Inc.
Asset management includes centralized management of network communications devices and IED passwords.
-
product
Test Set
ASE2000
The ASE2000 Test Set is a full-featured protocol test unit. It provides the user with a powerful and flexible tool for diagnosing communication problems and testing and maintaining RTU and IED equipment. The test set has three modes of operation, Master Simulation, RTU Simulation, and Line Monitor.
-
product
GOOSE Message Recorder
TR-61850
Whether a new or existing installation, AMETEK’s TR61850 adds the capability to easily monitor and record GOOSE messages within the substation. All data from the fault recorders and TR61850 automatically merge providing a single point of reference when analyzing transient events and system disturbances. With a wide range of time synchronization, communication options and small form factor, the TR61850 seamlessly integrates into any application.Configuration of the GOOSE Message subscriptions is quick and easy with AMETEK’s configuration tool. Using the IEC61850 Substation Configuration Language (SCL), third party IED Capability Description (ICD) files are imported and subscriptions are created by simply dragging and dropping available GOOSE message outputs.
-
product
Vehicular Armor Testing
NTS Camden (Arkansas) is an integral part of the NTS Defense Group. The facility has logged more than 20 years of experience performing destructive testing for the defense industry, and has provided IED and mine blast test services to some of the nation’s premiere armor and armor systems developers. NTS Camden is ready and able to assist armor manufacturers and developers in accurately assessing the performance of current and new armor designs against improvised explosive devices and mine blast threats.
-
product
System Amplifier
Solid state Broadband Amplifiers are designed for optimum operation for IED Jammer Applications which is featured as below. We can rack mount any of our existing amplifiers or systems or custom design the amplifier and enclosure. Each Rack Mounted Amplifiers are built around a large bonded fit heat-sink rated for high temperature ambient operation.
-
product
Bomb Jammer
Security Intelligence Technologies, Inc.
The Bomb Jammer is a defense technology used to counter RCIED theats. It comes in several configurations. The Covert Bomb Jamming System is our trunk mountable IED Jammer. Its low profile profile antenna setup make it an ideal vehicle jammer to defeat IED threats.
-
product
Universal Test Set
UTS
The Universal Test Set (UTS) is a portable, battery-powered, programmable, ruggedized radio frequency test set designed to validate improvised explosive device (IED) jamming equipment. Our unit is intended to provide an in-field confidence testing for warfighters employing IED jammers prior to departure.
-
product
High-Power Tunable Filter
CB503
The need for tunable filter technology originates from the fact that high power communication systems and IED Jammer transmitters severely limit the use of tactical radio communication systems on the battlefield.This clash within the radio’s spectrum during tactical missions is often de-conflicted using fixed high Q, high power RF bandpass and bandstop filters installed prior to mission. This can limit operational effectiveness due to the potentially large number of fixed filters required within the allocated radio communication channels, which need be transported, stored in the field, and fitted by trained personnel. Many of these fixed filters centred within the octave wide tuning range could be replaced by a single high-Q tunable filter.
-
product
Protocol Converters
Applied Systems Engineering, Inc
ASE provides a total solution approach to the area of protocol test equipment with its’ family of PC based protocol test products. The ASE2000 RTU Test Set is a full-featured protocol test unit that provides the user with a powerful and flexible tool for testing and maintaining SCADA RTU and SCADA IED equipment and diagnosing communication problems.
-
product
Roof Mounted Bomb Jammers
Security Intelligence Technologies, Inc.
The Roof Mounted Bomb Jammer series were the original IED Jammers. Our preliminary task was to design and utilize a radio jammer that would work for armored vehicle users, VIP users, and those traveling in convoys within hostile territories.
-
product
Explosive Test Site Range Instrumentation
Firesets, CDU’s EDU’s, Delay generators, firing panels, and custom instruments. Fiber-optic and computer-control options.
-
product
Devices
Aegis Industrial Software Corp.
Eventually your MES system needs to interact with the physical world and that means hardware is necessary. Aegis offers pre-certified devices such as scanners as well as line control devices of its own design. The benefit for customers is a successful implementation that comes from Aegis' experience of 1600 installations dealing with thousands of identification challenges and process control challenges.
-
product
Diagnosis Device
CANtouch
Gesellschaft für Mikroelektronikanwendung Chemnitz mbH
The CANtouch is a battery operated handheld diagnosis device for physical and logical CAN bus analysis. With its modern touch control it allows an intuitive and efficient handling without an additional computer.
-
product
Fiber-Optic Devices
Understanding that fiber-optic devices are key devices for building global information networks, Renesas has applied its advanced R&D, design, development, and quality management expertise to creating a diverse portfolio of products for a wide range of fiber-optic communications applications.
-
product
Proving Devices
Martindale Electric Proving Devices - safely prove the operation of voltage indicators and test lamps
-
-
product
Control Devices
Solutions for monitoring and recording any value you wish to manage (electricity, water, gas consumption, temperatures, flow rates, pressures, units produced, etc.), either through communications or through pulse logger systems. The control system family contains the LINE solution to create a comprehensive energy management systems (SGEi), LM pulse loggers and MDC controllers to avoid surcharges in the electric bill by preventing the contracted capacity in electrical installations from being exceeded.
-
product
Passive Devices
Fiber Splitters, Muxes, CWDM, DWDM, WDM, PON, Fiber Jumpers, Fiber Attenuators.
-
product
Measuring Devices For Nanoindentation
With our measuring devices, you can determine the mechanical properties of thin coatings reliably and accurately. From protective paint coatings to hardness of PVD coatings: We have the right solution for you. We offer you powerful and easy-to-use measuring instruments for the laboratory and production. You can choose from a wide range of accessories to adapt your device to your individual requirements.
-
product
Serial Device Servers
Connect and share RS-232 serial devices on wireless or wired Ethernet networks, with enterprise security support and multiple serial port modes for maximum flexibility in any environment.
-
product
Explosive Atmosphere Testing
Will your product operate in a highly volatile environment without creating ignition and causing an explosion? Explosive atmosphere testing provides vital information about motors, lighting systems, bilge pumps, aircraft components, electronics, and other systems. Explosive atmosphere testing determines whether a product will be able to operate properly in a fuel contaminated, highly volatile environment without creating ignition and causing an explosion. Causes of ignition vary from tiny electrical arcs in battery-operated equipment to hot spots on surfaces of sealed, encased units, to sparks from other mechanical sources.
-
product
Recorder Carrier Device
RCD
The RCD is a carrier signal demodulator for SCADA and Fault Data Recording. the RCD demodulates the carrier to indicate the presence of a relative level of a singal
-
product
* FlexRIO IF Transceiver Device
Enable Direct RF acquisition. Use in a dual Channel mode, or in a single-channel interleaved mode. I deal for applications that require wideband acquisition and generation with multichannel synchronization, including radar, electronic warfare, and communications.
-
product
Mobile Test Devices
burster präzisionsmeßtechnik gmbh
Device test, strain gauge simulator, sensor test, reference measurement chain
-
product
Electricity Metering Device
Mk10A
The Mk10A is another addition to the Atlas series which enhances the Mk10 meter with additional communications capabilities for use in Power Quality indication, advanced commissioning functionalities and larger memory storage.
-
product
Input Devices
In fact, our in-house electronics production capabilities, incorporating the most advanced technological trends, streamline and ease our customers’ ability to bring their concepts and designs to fruition. From complete assembly through automated placement of components on foil, our automated production machinery brings precision and reliability to the production process, while skilled manufacturing staff oversee and control all aspects of manufacturing. Post-production inspection then ensures that our – and our customers’ – highest standards are met.
