Filter Results By:
Products
Applications
Manufacturers
- Pickering Interfaces Inc.
product
PXI 10A Fault Insertion Switch 6-chan 2-bus
40-192-012
This PXI fault insertion switch uses solid state switching elements and is capable of switching current up to 10A. It is designed to be able to insert three different fault conditions between the test fixture and the equipment under test: Open-Circuit. Short-Circuit between UUT connections. Short-Circuit to external signals. Through relays on each channel enable signals to the UUT to be set open-circuit. Fault Insertion Buses allow any channel to be shorted to any other channel and also enable any channel to be connected to an external signal such as Power, Ignition or Ground to simulate fault conditions. The module is supplied with 2 fault buses.
-
product
CDI Ignition Coil
An on-plug coil for use with Capacitive Discharge Ignition (CDI). Design and manufacture is in-house, so we can make the coil to suit your specific application. The information given here is for a typical coil. Many of the parameters can be tailored to a particular installation.
-
product
Fanless AIoT Video Analytics Platform with NVIDIA Jetson AGX Xavier for Railway
AVA-RAGX
- NVIDIA Jetson AGX Xavier with 32 TOPs AI performance- 4xM12 GbE with PoE, 1x lockable HDMI output, 4x USB 3.0- 1x M.2 B-key for LTE/5G; 1x M.2 A/E key 2230 for Wi-Fi- 2x CAN DB-9 CAN-FD from AGX module, with isolation- Power with ignition control- Nominal Voltage: 24VDC, 36VDC, 72VDC and 110VDC (EN50155 compliant)
-
product
Measurement & Diagnostic Products
DURST Motor & Electric Industries Pty Ltd.
DURST Measurement & Diagnostic Products; circuit tester, vehicle battery analyzer, multimeter, dedicated automotive multimeter, clamp meter, sound level meter, oxygen sensor tester, diesel engine tachometer, multisystem ignition analyzer, faultfinder, circuit tester, diode tester, regulator tester, growler for testing motor insulation, armature/commutator tester, diagnostic testers, current clamps, optical photo/contact tachometer, etc.
-
product
D.V.A. Adapter
640
*Read peak volts on CD ignition coils with your existing digital multimeter *New, completely redesigned unit is half the size of the previous adaptor *Adapts standard digital multimeter into peak reading voltmeter *High quality test leads with alligator clips are incorporated into the adaptor
-
product
SPI Flammability Tester (Vinyl Material)
TF318
TESTEX Testing Equipment Systems Ltd.
SPI Flammability Tester (Vinyl Material), to determine the ignition properties of vinyl plastic film material according to CFR 16 Part 1611 U.S.A. Flammable Fabrics Act for flammability of apparel vinyl plastic film.The rate of burning shall not exceed 1.2 in./s as judged by the average of five determinations lengthwise and five determinations transverse to the direction of processing, when specimen is placed at an angle of 45 degree and expose to the standardized flame (22# fire nozzle, 1/2 inch. In length).
-
product
VVDI Key Tool
*For renewing the original keys (BMW F series and E series, Audi smart key, Porsche ..)*transponder – reading and precoding*copied transponders with SNIFFER function*pilots – test and cloning*test coil immo with ignition
-
product
ATEX / FM Approved Grounding Clamps, Cables and Reels
Cen-Stat Static Grounding Clamps
Static grounding systems like the Earth-Rite range combine interlock control and visual indication to verified ground connection points and offer the highest levels of protection over electrostatic ignition risks. However, equipment specifiers may select passive grounding devices, like single pole clamps, to ground and bond plant equipment.
-
product
Diesel and Gasoline Engine Tachometer
TA303
The TA303 Smartach is a tachometer designed for use on any engine equipped with an alternator, and only requires a simple connection to the electrical system (e.g. battery, alternator, cigarette lighter connector) to measure engine RPM. Taking advantage of the ripples generated by the alternator, the TA303 automatically calculates the relationship between the speed of the engine and the alternator ripples, and uses them to measure RPM on any piston engine regardless of its ignition system (Diesel or gasoline).
-
product
Ignition Pulse Detector
IP-292/296
These detectors are electromagnetic induction type detector designed to detect the number of ignition pulses produced in the gasoline engines. The IP-292 pinches a primary cord (low voltage) and the IP-296 pinches a secondary cord (high voltage) of the ignition coil. The compact, light-weight and clip-on design of these detectors offer a simple and easy detection of the number of pulse. Since the detector and its cord are made of heat resistance materials, these models are not affected by the high temperature in the engine room. These detectors are used with the engine tachometers made by Ono Sokki. (AR-7240B, CT-6700, HT-6200, SE-1620, FT-2500 or GE-2500)
-
product
Flame & Other Plastics Testing
Educated Design & Development, Inc.
Plastics are tested to determine their flammability burning characteristics (Flame rating), their ignition potential due to thermal and electrical sources, their resistance to electrical tracking, and other electrical characteristics. The specific test required on a plastic depends on the type of component or end-use product, as well as the environment in which the plastic is used. This test equipment meets most UL, CSA, IEC, EN and other international safety standards.
-
product
Electronics & Power
Excelitas Technologies offers a wide range of high-performance electronics, power and energetics technologies to drive your most demanding photonic systems. Our Electronics & Power offering includes Capacitor Chargers, Spark Gaps and Transformers, High-Voltage DC Power Supplies and Atomic Frequency Standards. Our Energetics portfolio includes Electronic Safe & Arm devices, Detonators, Ignition Safety devices, and Rocket Motor Initiators.
-
product
Instruments
Shenzhen Zeus Information Technology Co., Ltd.
Shenzhen Zeus Info Tech Co., Ltd. Instruments, motorcycle fuel pressure gauge, auto ignition coil tester, digital multimeter, circuit tester, automobile insulation resistance tester, voltage detector, etc.
-
product
Rocket Motor Initiators
Our patented Rocket Motor Initiators and Through Bulkhead Initiators are designed to work with single- and multiple-pulse rockets, as well as those platforms that might not currently have MIL-STD-1901A-compliant initiators. Excelitas initiators are designed to work in conjunction with our Ignition Safety Devices and low-energy, low-profile Blue Chip® Detonators to provide a comprehensive and reliable rocket ignition and firing solution.
-
product
Digital Tach/Advance Timing Light
125
*Professional Timing Light with High Visibility LED display Very bright display indicates: - Tach (RPM) - Degrees Advance *Measures ignition spark advance from 0-90 degrees *2 & 4 Stroke Tachometer measures engine speed up to 9,999 RPM *Brilliant Xenon flash at all speeds *Detachable & replaceable cable set *Designed for precise tuning and diagnostic work *Accurate up to 9,000 RPM *Works with 12 Volt electrical systems
-
product
Low Gauge Vacuum Tester
G4103
Suitable for use on all petrol engines and easily fits to most vehicles. Accurately measures pressures within the range minus 1 bar (30mHg) to plus 0.7 bar (10psi). Applications include: Engine Fault Finding, by using the gauge as an inlet manifold vacuum tester the following faults can be diagnosed: spark misfires, poor engine compression, mixture tool weak or too rich, ignition too advanced or too retarded, inlet manifold and carburettor air leaks, incorrect valve timing. Turbo boost gauge; testing boost pressure up to 0.7bar (10psi) and Petrol Pump Tester; tests electrical and mechanical petrol pumps (excluding high pressure pumps used on fuel injection engines)
-
product
D.V.A. /Peak Reading Multimeter
530
The #530 was designed in conjunction with the industry’s leading outboard engine manufacturers. The #530 is used to diagnose problems in CD (capacitive discharge) ignition systems. An essential tool for the professional marine service technician.
-
product
Cigarette Lighter Socket Sensor
FT-0801
The FT-0801 cigarette lighter socket sensor detects ignition noise of voltage from cigarette lighter socket sensor as rotation signal. Useful for signal detection from a cigarette lighter socket equipped in an automobile or construction machinery.Rotation signal can be detected from a cigarette lighter socket by using the FT-0801 even if it is difficult to attach a rotation detector inside of an engine room.
-
product
Gasoline Engine Tachometer
SE-2500A
SE-2500A is a non-contact handheld tachometer designed for gasoline engine measurement. Detection, measurement, and display parts are all in one unit and batteries are built in the unit. Moving the detector (head of the SE-2500A) close to an ignition coil can measure rotation speed at the unit of 1 r/min or 0.01 r/s. Up to 20 measurement data can be stored in the internal memory that is convenient for later checking.
-
product
Coil-on-Plug Spark Tester
TH458
For ignition systems with coil-on plugs, including Ford, Chrysler, Chrysler imports, Mitsubishi, Nissan, and more. Since coil-on plug ignitions do not have plug wires, inductive test equipment cannot be used. Spark tester tests for no-start conditions and measures coil output.
-
product
NFPA 701-2 Flammability Tester
TF321
TESTEX Testing Equipment Systems Ltd.
NFPA 701-2 Flammability Tester, to determine the ignition resistance properties of draperies and other hanging fabrics according to test method NFPA 701#2, and it is suitable for single-layer or multi-layer fabrics, fabrics with density larger than 700g/m2 (21oz/yd2), and fabrics coating with polyethylene, etc.
-
product
Explosive Atmosphere Testing
Will your product operate in a highly volatile environment without creating ignition and causing an explosion? Explosive atmosphere testing provides vital information about motors, lighting systems, bilge pumps, aircraft components, electronics, and other systems. Explosive atmosphere testing determines whether a product will be able to operate properly in a fuel contaminated, highly volatile environment without creating ignition and causing an explosion. Causes of ignition vary from tiny electrical arcs in battery-operated equipment to hot spots on surfaces of sealed, encased units, to sparks from other mechanical sources.
-
product
Multisystem Ignition Analyzer
TA500
The TA500''s unique and proprietary technology allows the user to perform quick and reliable diagnostics of non-starts, misfires, fouled up or damaged spark plugs and/or spark plug wires, by comparing digital read-outs of the spark plug voltage and spark burn time between cylinders on engines using Coil on Plug, Coil near Plug, conventional distributor/ignition coil, DIS (Distributor-less) or waste spark and magneto technologies.
-
product
Position Sensors for Hazardous Environments
Intrinsically Safe systems provide a safe operating environment for personnel and equipment. Intrinsic Safety (IS) is based on the principle of restricting the electrical energy transmitted into a hazardous area, thereby ensuring that anysparks or heated surfaces that may occur as a result of electrical failures areinsufficient to cause ignition. The threat of an explosion is eliminated.
-
product
Gasoline Engine Tachometer
SE-1620
The SE-1620 is an engine tachometer that performs measurement of the number of revolutions of a gasoline engine by connecting an engine revolution sensor such as an ignition pulse detector. A 100-mm wide-angle meter is used for the display, and both analog output and pulse output functions are provided as standard.Simply attach an ignition pulse detector or one of our other compatible detectors to the engine to enable measurement of the number of revolutions of a gasoline engine. The inputs, outputs and input power supply are all isolated to ensure the output of analog and pulse signals with superior noise resistance and stability characteristics.
-
product
Adjustable Ignition Spark Tester
404
For all ignition systems from high energy electronics to small engines. Tests for no-start conditions and for spark strength.Adjustable gap for spark gap requirements from 0-40,000V. Gauge background makes spark easy to see.
-
product
Static Grounding Protection for Tank Trucks
Earth-Rite RTR
Precision and reliability is what the Earth-Rite RTR provides to HAZLOC safety professionals and engineers who are tasked with protecting personnel and plant assets from the ignition hazards of static electricity during tank truck loading and unloading operations.
-
product
Carpet Flammability Tester
TF317
TESTEX Testing Equipment Systems Ltd.
Carpet Flammability tester is used to test the effects of a small source of ignition on floor coverings. Carpet flammability tester can be used for either Hot metal nut test (BS 4790) and Methenamine tablet test (ISO 6925, BS 6307 and GB/T 11049)
-
product
Combustion Enginee Analyzer
Internal Combustion Engine Measurement, Analysis and ThermodynamicsComplete combustion measurement and analysis system for internal combustion engine research and development, optimization and testing of ignition systems, exhaust systems, and valve control gear.
-
product
SECONDARY IGNITION PICKUP
MD75300
*Safely acquire high voltage waveforms with this high impedance, active pickup*Works with spark plug wires and coil on plug ignitions with MDAUTOWAVE, AUTOWAVECAMO and MDAUTOWAVE2*Adjustable sensitivity increases waveform acquisition accuracy
-
product
Connector and Breakout Box
ES4640
The ES4640 Connector Box offers a standardized wiring and connectivity for HiL testing systems in the powertrain domain. Its front panel provides connectors for the ECU, CAN bus communication, on-board diagnostics, and LEDs for ignition and injectors. Its rear panel connects loads, failure simulation, and other components. Sample applications of the ES4640 are closed loop HiL systems for 8 cylinder gasoline and diesel engine ECUs.
