Filter Results By:
Products
Applications
Manufacturers
- Valhalla Scientific Inc.
product
Air Force
Alpha 4314 AF
4314AF introduces an added safety feature that prevents the possibility of having the charging adapter connected while using the instrument for measurements. A 6-pin Mil-Spec circular connector on the front panel of the 4314AF replaces the four-terminal banana jacks and the battery charger jack. Four of the front panel connector pins are used to mate with the measurement adapter cable and the other two pins are for the battery charging cable adapter. By using separate adapter cables for measurements and charging of the batteries, it ensures that the charge circuit cannot be activated at the same time as measurements are being made.
-
product
Airborne Ultrasound Sensors
Find compressed air, gas and vacuum leaks in noisy environments. Increase your inspections distance and reach hard to access areas.
-
product
Sand and Dust Chamber
Designed to test a product’s resistance to extremely dusty, desert-like environments, Thermotron’s D-27 Sand and Dust Chamber provides the capability of meeting specific automotive test standards. Powerful blowers intermittently blow compressed air up through finely powdered dust and then allow the dust to settle back down covering the product.
-
product
Fully Automatic Solar Cell
Module Laminator-H
1. Model: BSL2236OAC-H2. Effective lamination area: 2200mm × 3600mm3. Dimensions: length 17410mm × width 3665mm × height 2164mm4. Heating method: heat conduction oil heating5. Compressed air source pressure: 0.6～0.8MPa6. Working vacuum degree: 100～40Pa7. Evacuation rate: 70L/S8. Temperature control accuracy: ±1.5°C9. Temperature control range: room temperature - 180°C10. Temperature uniformity: effective lamination area≤±2℃11. Lamination chamber height: 30mm12. Evacuation time: depending on the process, it is recommended to take 5 to 8 minutes13. Upper cover stroke: 300mm
-
product
Compressed Air Temperature and Humidity Regulator
H3021P-2
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Bench Top Ionizers
Point-Of-Use Ionizer, Adjustable (30-100 PSI) Compressed Air IonizerNeutralize Electrostatic Attraction (ESA) to control contamination by dislodging dust and debris attracted by static electricity.Detachable 7'' long ESD Protective Flexible Hose with Thumb Button Designed to for a wide range of motion and simple operation.Adjustable Balance (20 Volts) with Less Than 1 Second Discharge Time At 6 InchMeets required limits ANSI/ESD S20.20 tested per ANSI/ESDSTM3.1 and ESD TR53
-
product
Compressed Air RH+T+Tdp Sensor
T0211P-4
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Dual Vapor Gravimetric Sorption Analyzer
DVS Resolution
DVS Resolution’s key feature is the combined ability to precisely control and measure temperature and relative humidity while recording the highest resolution changes in mass. DVS Resolution uses a dry carrier gas typically nitrogen or compressed air for its operation. Digital mass flow controllers regulate flows of dry and saturated gases. Relative humidity is generated by precisely mixing dry and saturated gas flows in desired flow ratios which produce expected relative humidity. In a typical experiment a known concentration of water vapor is delivered over a sample placed inside the sample pan connected to the Surface Measurement Systems Ultrabalance™ measuring realtime mass changes caused by sorption or desorption of water molecules. Prior to sorption measurements, the sample can be in-situ preheated/dried at temperatures of up to 300oC.
-
product
Air Tightness Detector
FQ
Fuzhou Fuguang Electronics Co., Ltd.
FQ series air tightness tester is the latest high-precision non-destructive testing equipment developed by Fuguang Electronics. The equipment mainly uses compressed air as the medium to apply a certain pressure to the inner cavity or surface of the product to be tested, and then uses a high-sensitivity sensor to detect changes in pressure to determine the tightness of the product to be tested.
-
product
Ultrasonic Leak Detector
Tru Pointe 1100
The Tru Pointe® 1100 is an ultra-versatile ultrasonic leak inspection system that can be used for both leak detection and mechanical inspection/troubleshooting. It is capable of finding leaks of any gas type, including refrigerants, air (compressed or vacuum) and nitrogen. The Tru Pointe® Ultra can also be used for thermal expansion valves, steam traps, bearings and more.
-
product
DP Monitor for Compressed Air Systems
Com.Air
The Com.Air dew point monitor has been designed by Edgetech Instruments to offer the highest level of reliability and accuracy available in compressed air system dew point measurement.
-
product
Acoustic Imaging Cameras
Acoustic imaging cameras feature precise sound localization and real-time visualization of sound fields. Transforming complex sound data into intuitive images. Supporting partial discharge & compressed air leak detection. They are widely applied in manufacturing, automotive, aerospace, power generation, and environmental monitoring, for noise source identification, leak detection, equipment health monitoring, and noise pollution control.
-
product
Ultrasonic Leak Detection Camera
Leakshooter LKS 1000-V.2
1st ultrasonic compressed air, gaz and vacuum leak detector with camera. Specialy dedicated to visualize the spots where compressed air is leaking, the LEAKSHOOTER LKS 1000 – V.2 has many other applications such as : steam trap monitoring, bearing monitoring, electrical applications like partial discharge, corona effects, punctured isolators, electrical tracking detection.
-
product
Air Amplifiers
Nex Flow® Air amplifiers are compact, low cost air flow “movers” that are virtually maintenance free. Applications include the venting of fumes and smoke, conveying of low weight materials, and entraining a high volume of air to cool, blow off, and dry. Air Amplfiiers use the “Coanda effect” to draw in the surrounding atmosphereic air while consuming only aminimal amount of compressed air. These products can amplify airflow up to 17 times (depending on the size) resulting in dramatcally reduced levels of noise. Air Amplifiers (also called Air Movers) draw in atmospheric air from the back of the unit as well as having downstream entrainment further amplifying the flow. They are used for cooling and venting. While the force produced for blow off decreases as the amplifier outlet diameter increases, these Air Movers are ideal for cooling because of the high velocity outlet fow and and are much more effective for cooling compaed to air nozzles.
-
product
Compressed Air Temperature and Humidity Regulator
H3061P-2
Relative humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Compressed Air Temperature and Humidity Regulator
H3061P-4
Relative humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Portable Leak Detection
Ultrasonic
Bacharach's ultrasonic-based leak detectors support a variety of applications, including: Combustible and Refrigerant Gases, Compressed Air and Pneumatic Systems, Inert Gases (CO2, Nitrogen, Helium, etc.), Steam Trap Leak Detection, Condensate Flow, Thermal Expansion Valves (TXV), Solenoids, Mechanical Problems (Bearings, Wear), Electrical Arcing, Sealed Enclosures, Tanks, and Rooms, and Condition-Based Monitoring:
-
product
Electronic Pressure Switch With Digital Display (Pallect Pressure Switch)
PPD3
30mm, 1 color display compact pressure switch.The stainless diaphragm option (PPD3-S) can measure the pressure of compressed air containing water such as drainage.
-
product
Flipper
H71007100
Easy operator access for loading and unloading the DUT, thanks to the flip operation performed by the Flipper module. Combined test (Hipot, ICT & Funcional) Rack&stack module for 19 inch frame 6 U height (266,7 mm 10.5”) Pushing force up to 900N (more than 400 needles @2N) Power supply 230V 50-60 Hz. Compressed air not required High dynamics and precission CNC servocontroller PCB areas up to 232x358mm. Bigger areas available under request. Interchangeable cassette for upper bed of nails or actuators
-
product
Flowmeters for Compressed Air and Specialty Gases
Type SD
*Measurement to ISO 2533 and DIN 1343*For compressed air in industrial use as well as argon (Ar), carbon dioxide (CO2), nitrogen (N2)*Large measuring range up to 700 Nm³/h*Fast response time and high response sensitivity*With volumetric flow quantity, total quantity and temperature indication
-
product
Ultrasonic Leak Detector
Tru Pointe Ultra
The Tru Pointe® Ultra is a low-cost handheld ultrasonic leak detector capable of finding leaks of any gas type, including refrigerants, air (compressed or vacuum) and nitrogen. The Tru Pointe® Ultra can also be used for thermal expansion valves and steam traps, making it a very versatile leak detector.
-
product
Leak Detection
Compressed air is an expensive energy 20-40% are lost in leaks. The systematization of hunting leaks allows significant energy savings. Shoot, view and photograph the precise location of compressed air leaks , steam, gas pressure and vacuum through LEAKSHOOTER LKS1000 V.2.
-
product
Miniature Flow Sensor For Gas Lapiflow (R)
FSM
Ultra-compact flow sensor for compressed air and nitrogen gas.Since it is lightweight and responds quickly, it is ideal for confirming the adsorption of electronic parts.
-
product
Test Adapter / Pneumatic Adapter
GPS testing technology offers a wide range of pneumatic adapters. The support with compressed air results in increased ease of use and larger pressures can be built up easily and thus more test needles can be contacted.
-
product
Dew Point
Rotronic Measurement Solutions
ROTRONIC Low dew point measurement simply explained. Low dew point probe. Reliable measurement of trace moisture. One probe for portable, fixed or OEM applications. Ideal for compressed air with dew point as low as -60°C; desiccant or refrigeration dryers.The low dew point probe comes with the latest AirChip4000 technology. Calculates a measurement from the average of 8,000 single points within a 2 second interval and, together with the HYGROMER® LDP-1 dew point sensor, delivers measurements of the highest quality.
-
product
LVDT With Pneumatic Function
INELTA Sensorsysteme GmbH & Co. KG
2-3 bar compressed air moves the strings out the integrated return spring pulls the output back into the housing
-
product
Compressed Air Temperature and Humidity Regulator
H3021P-4
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Thermo-Hygrometer
C3121P
Thermometer, hygrometer is designed for direct measurement of temperature, relative humidity for compressed air up to 25 bars with 1m cable. Audio and optical alarm of measured values. Memory of minimum and maximum measured values. Function Hold - manual storing of actual values for later displaying.
-
product
Compressed Air RH+T Transmitter
T3419P
Humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Pulse AC Method Area Ionizers
ER-X Series
Panasonic Industrial Devices Sales Company of America
The ER-X Series Area Ionizers utilize the pulse AC ionization design to achieve high-speed charge removal of wide surface areas for high-volume production lines. In addition to supporting compressed air ionization, the ER-X also features both airless and low-pressure ionization modes for applications where tiny workpieces can be easily blown away. Additional features include automatic ion balance and discharge frequency control (manual control is also possible), flat discharge surface for easy cleaning, discharge needle air barrier design to reduce contamination of the needles, replaceable discharge needle unit for easy maintenance, and a dual head configuration for enhanced charge area and layout (2 different ionizer heads can be connected to a single controller).
-
product
Compressed Air RH+T+Tdp Sensor
T3111P-2
Relative humidity, temperature sensors at probe on the cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
