Filter Results By:
Products
Applications
Manufacturers
-
product
Mixed Gas Generators MU Series
MU-2200
The mixed gas generator MU Series integrates with high-performance mass flow controllers to generate a homogenous gas mixture of two or more types of gases. Using the control unit’s touch panel you can control both flow rate, and the concentration of the mixed gas.The gas generators can be used for industrial purposes, such as generating combustion gases supplied to burners, as well as laboratory use in the biotechnology and food markets. HORIBA produces gas mixers tailored to customers’ intended uses, such as models with a purge function capable of mixing reactive gases.
-
product
2x8 Coherent Mixer With Single-ended Photodetectors
This page defines the requirement of a special coherent receiver with 8 single-ended photodiode outputs, per customer request. The coherent mixer, consisting of two polarization-diversified 90deg optical hybrids, a polarizing beam splitter and a beam splitter, is exactly same as existing DP-QPSK coherent mixer, and therefore offering same optical performance.
-
product
Noise Figure Measurements With Vector Correction
S95029B
The S95029B noise figure application enables high-accuracy noise figure and noise-power measurements of amplifiers, frequency converters, and mixers by using the Keysight vector-source-correction technique. Using a source-impedance tuner to remove the effects of imperfect system-source match, this technique produces higher accuracy results than Y-factor method and other cold-source implementations--especially for in-fixture, on-wafer, and automated-test environments.
-
product
RF Training Kit And Lab Sheets
Y1800A
The RF transceiver kit consists of a transmitter unit and a receiver unit in superheterodyne architecture. The transceiver units are made up of various RF building-block modules such as filter, low noise amplifier, power amplifier, mixer and oscillator. The RF transceiver kit is controlled by a Windows-based Control Panel software via USB. A Measurement Automation Program is provided to demonstrate automated characterization and test of RF circuits. A signal generator and a spectrum analyzer are required to run this program.
-
product
Microwave Downconverter, 3 GHz to 26.5 or 110 GHz
E5053A
The E5053A microwave downconverter is designed to operate with the E5052A/B signal source analyzer (SSA). When configured with the E5053A microwave downconverter, the E5052A/B SSA offers exceptional phase noise sensitivity up to 26.5 GHz. Additionally, combining a pair of 11970 series harmonic mixers offers the phase noise measurement up to 110 GHz.
-
product
Differential And I/Q Device Measurements
S96089B
The S96089B combines source-phase control of multiple internal or external sources with frequency-offset mode, enabling simplified test of I/Q modulators/converters, differential mixers, and harmonics or amplifiers.
-
product
Millimeter-Wave Mixers
Teledyne Lincoln Microwave design and manufacture custom Single Balance Mixers for operation up to 110 GHz.
-
product
Phase Noise Measurement Up To 125 GHz
S930321B
S930321B enables phase noise measurements using a PNA or PNA-X vector network analyzer. Simplify your measurement workflow by measuring phase noise on the same connection as your network analysis measurement of 2-port active devices up to 125 GHz, without needing to connect a spectrum analyzer or harmonic mixer.
-
product
Gas Mixers
Get the right gas mixture and flow rate using our Gas Mixers for Modified Atmosphere Packages. We offer gas mixers for CO2, Oxygen, Nitrogen, and Argon gases.
-
-
product
Waveguide Harmonic Mixer, 33 to 50 GHz
11970Q
The Keysight 11970Q waveguide mixer is a general-purpose harmonic mixer employing a dual-diode design to achieve flat frequency response and low conversion loss. These are achieved without external dc bias or tuning stubs. Manual operation and computer-controlled hardware operation are simplified because mixer bias and tuning adjustment are not required.
-
product
Equalizer 2K Dispensing Tool
The pneumatically-operated tool accurately dispenses 2K materials packaged in EFD 50mL Side x Side cartridge systems and static mixers
-
product
Schottky Mixer Diodes
Teledyne Lincoln Microwave GaAs beam lead Schottky diodes for the up/down conversion of millimetre wave detected signals are designed for applications which demand ultimate performance. The device is easily assembled onto a wide variety of surface mount substrates using thermo-compression, thermo-sonic or epoxy bonding techniques.
-
product
Millimeter-wave and Microwave GaAs Mixers
Keysight Technologies provides MMIC mixers ideal for microwave radio, aerospace and defense, and instrumentation applications.
-
product
Vector And Scalar Mixer/Converter Measurements
S93083B
The S93083B provides both fully calibrated vector and scalar measurements of mixers and frequency converters, with intuitive, easy-to-use user interface
-
product
Phase Noise Measurement Up To 70 GHz
S930317B
S930317B enables phase noise measurements using a PNA or PNA-X vector network analyzer. Simplify your measurement workflow by measuring phase noise on the same connection as your network analysis measurement of 2-port active devices up to 70 GHz, without needing to connect a spectrum analyzer or harmonic mixer.
-
product
Comb Generator, 10 MHz to 26.5 GHz
U9391C
The Keysight Technologies, Inc. U9391C comb generators were developed to provide precision phase calibration, for non-linear measurements using the PNA-X nonlinear vector network analyser (NVNA), referenced to the National Institute of Standards and Technology (NIST) standard. Additionally, the comb generators can be used to calibrate PNA and PNA-X network analyzers for phase and delay measurements of frequency converters without requiring reference or calibration mixers.
-
product
Mixers
FS-Z
RPG offers broadband harmonic mixers with an integrated isolator (50 – 220 GHz) for optimum RF matching. Hence standing waves, usually degrading RF power measurement accuracy, are suppressed.
-
product
Spectrum Analysis, Up To 26.5 GHz
S930902B
The S930902B spectrum analysis adds high-performance microwave spectrum analysis to the PNA family up to 26.5 GHz. With fast stepped-FFT sweeps resulting from optimized data processing, the SA application provides quick spurious searches over broad frequency ranges. Simultaneous spectrum measurements can be done using up to five test and reference receivers. This multi-channel SA can be used with the internal swept-signal generators for efficient measurements of spurious signals emanating from mixers and frequency converters. The SA application employs source-power and receiver-response calibration as well as fixture de-embedding, providing in-fixture and on-wafer spectrum measurements with the highest level of accuracy.
-
product
Direct Digital Synthesis (DDS)
Analog Devices’ world leading direct digital synthesis ICs incorporate features such as on-board comparators, RAM, PLLs, mixers, and registers. This makes them an ideal agile frequency synthesizer solution in systems for communications, test equipment, and radar.
-
product
RF Mixers & Frequency Converters Overview
Up and down conversion is often used because waveform generation in a transmitter is less expensive at lower frequencies and the dynamic range of analogue-to-digital converters in the receiver is higher at lower frequency.
-
product
Do-It-Yourself (DIY) Dual Syringes
Nordson EFD offers disposable dual syringes and static mixers that provide controlled mixing and placement of two-part epoxies, adhesives, sealants, gels, pastes, and compounds used in a range of DIY home improvement, automotive, health and beauty, and dental applications.
-
product
Emulsion Mixers
4818
Parker Conflow’s Code 4818 is a unique emulsion mixer which supplies a constant, accurate mix ratio of soluble oil and water to provide fire-resistant hydraulic fluid to power roof supports on the coal face.
-
-
-
product
I/Q Upconverters/Transmitters
In-phase quadrature (I/Q) upconverters integrate an I/Q mixer, RF amplifier, 90° hybrid, and an LO buffer in one package. These devices are used in transmitter applications to upconvert intermediate frequency (IF) to a desired radio frequency (RF) while reducing the need for filtering unwanted sideband.
-
product
MR Mixers
MR2L and MR10L mixers are used to condition wheat before test milling, and for a wide range of other mixing applications.
-
product
MMW Field Sensors
ITS-9050
The Innovative Technical Systems ITS-9050 Detector is a sensitive, harmonic mixing detector designed to measure millimeter-wave free-space radiation. It is ideal for measuring radiation patterns of antennas inboth the near and far-field. The ITS-9050 employs a free-running dielectric resonator oscillator (DRO) and an integrated harmonic mixer with a waveguide RF input that either connects directly to a circuit under test or to an antenna for radiation detection. The resulting IF is amplified and detected by an IF log-detector that drives a front panel LCD voltmeter to provide an indication of signal strength. A DC output voltage from the log detector is available on a BNC connector to drive external data acquisition instrumentation. Also, a sample of the IF output is provided for measurement on a spectrum analyzer.
-
product
IQ Networks
Teledyne RF & Microwave offers a capable range of high performance IQ Modulators and Image Reject Mixers as well as IQ (Quadraphase) Modulators which can be used on applications from commercial test equipment to space qualified projects. IQM products can be used either as an IQ modulator or IQ demodulator and cover several frequency bands from 1.4 GHz to 18 GHz. Click on the model number to view the available datasheets.
-
product
I/Q Downconverters/Receivers
In-phase quadrature (I/Q) downconverters integrate an image reject mixer, a low noise amplifier, a 90° hybrid, and an LO buffer amplifier in one package. These devices are used in receiver applications to downconvert radio frequency (RF) signals to the desired intermediate frequency (IF) while ensuring low noise and high image rejection performance.
